New 2.5-6Kg/time Adjustable Speed Stainless Steel Vegetable Water Dehydrator
New 2.5-6Kg/time Adjustable Speed Stainless Steel Vegetable Water Thrower Dehydrator. This product has exquisite design, simple and reasonable structure and high work efficiency.
All parts that come into contact with food are made of stainless steel or with special surface treatment, in line with national hygiene standards. Easy to use, flexible and convenient operation, high production capacity: Put the cut block materials into the bucket, run for about 1-2 minutes to dehydrate, and can also be used continuously, such as soy milk removal, etc. The machine is made of high-grade stainless steel, which is hygienic and durable, and can be used for soymilk removal, dehydration, oil removal, vegetable water removal, etc. Which is simple and practical.
This series of dehydrators are widely used in hotels, restaurants, restaurants, and food processing plants. And the canteens of each unit need to desizing, dehydrating, de-oiling, de-vegetable water, etc. Diameter of the inner tank. Diameter of the outer tank. Do not put your hands or other foreign objects into the bucket to avoid injury or damage to the machine.This machine is equipped with a motor overload protection device. In the event of overload or blocked rotation, the motor is automatically cut off from power. When the motor cools down to a point where there is no burning sensation when touched by hand, the motor thermal protection switch resets, providing safety protection for the motor. If the machine is operating normally and there is no wastewater or a small amount of waste residue coming out of the drainage pipe, the drainage pipe is blocked and only needs to be unblocked.
This machine is not suitable for individuals with physiological defects, disabilities or intellectual disabilities (including children), or lack experience and common sense, unless there are relevant regulatory personnel supervising or guiding the operation to ensure their safety. Be careful not to let children play with this machine.This machine cannot be cleaned with a water spray. Before using the filter bag, please clean it thoroughly before use. After each use, it is necessary to clean it thoroughly before storage. Check that the power voltage meets the specified requirements, the power wiring should be firm and reliable, and the power socket should be firmly grounded.
Place the vegetable dehydrator on a level surface. Place the vegetables that need to be dehydrated in the dehydration box. Before dehydration, please manually evenly place the vegetables in the dehydration box to prevent equipment shaking due to imbalance. Turn on the power, set the dehydration time as required to 1-5 minutes, and start the machine. Open the upper cover and remove the dehydration box and the processed product. After completing the work, remove the upper cylinder cover, remove the dehydration frame, and clean the inside of the material barrel. We do not assume any responsibility for failures and accidents caused by improper use by users. It is forbidden to use oversized solids and other hard and overweight bulk materials for dehydration.To ensure the safety of electricity use, it is necessary to regularly check the cable and whether the circuit is in good condition. It is forbidden to use when the insulating layer of the relevant circuit is damaged. The grounding of the dehydrator must be good, and it is strictly forbidden to operate the machine with bare feet and wet hands.
When the machine is just started or gradually suspended, the body needs to be supported to prevent the machine from swinging too much and causing accidents. When the dehydrator is working, or the power supply has been cut off but the sieve is still rotating, it is strictly forbidden to use hands or other tools to enter the sieve to get the material. In case of excessive load, lumpy materials or uneven distribution of materials, the machine is caused to work abnormally due to excessive shaking force. First, quickly stabilize the machine and then cut off the power supply (to prevent the machine from falling and causing a safety accident) , if it is overloaded, you should slowly take out a certain amount of block materials in the sieve (in line with the rated working weight of the machine) before continuing to work.
If the material is uneven, the material should be placed flat again, and then the machine should be turned on for work. When the dehydrator is not used for a long time, be sure to disconnect the power supply, and use waterproof, moisture-proof, dust-proof and other protective measures? When the machine is working, it is forbidden for children to play near the machine to avoid safety accidents.